Users Guide
To disable the LACP link fallback member, use theno lacp link-fallback member-independent
port-channel 128 command.
Command Modes INTERFACE
Supported Modes Standalone, Stacking
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the M I/O Aggregator and FN I/O Aggregator.
lacp long-timeout
Congure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout command.
Defaults 1 second
Command Modes INTERFACE (conf-if-po-number)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command applies to dynamic port-channel interfaces only. When applied on a static port-channel, this
command has no eect.
lacp port-priority
To inuence which ports will be put in Standby mode when there is a hardware limitation that prevents all compatible ports from
aggregating, congure the port priority.
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
priority-value Enter the port-priority value. The higher the value number, the lower the priority.
The range is from 1 to 65535. The default is 32768.
Link Aggregation Control Protocol (LACP)
245