Users Guide

Defaults 60 seconds
Command Modes VLT DOMAIN
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S4820T, S4810, S6000, S5000, Z9000, S6000–ON and Z9500.
Parameter
Enter the value (in seconds) to specify the time interval for delay restore timer to abort. This timer is
applicable only during reload/boot-up and not in other scenarios (example, ICL ap).
The range is from 1 to 1800 seconds.
Usage Information To abort VLT delay restore timer as the maximum threshold, the maximum time interval is applied to hold
down ICL peer-up in the start-up congurations during the reload.
io-aggregator auto-lag enable
Enable auto-lag globally on the server facing ports
Syntax
io-aggregator auto-lag enable
To disable the auto-lag, use the no io-aggregator auto-lag enable command.
When disabled, all the server ports associated in a LAG are removed and the LAG itself gets removed. Any
LACPDUs received on the server ports are discarded.
Defaults Enabled
Command Modes CONFIGURATION
Supported Modes Standalone, Stacking, VLT
Command History
Version Description
9.6(0.0) Supported on the FN I/O Aggregator.
9.6(0.0) Supported on the M I/O Aggregator.
Related Commands show io-aggregator auto-lag status—displays global information on the auto-lag status.
lacp link-fallback member
Enable the LACP link fallback member feature.
Syntax
lacp link-fallback member-independent port-channel 128
244
Link Aggregation Control Protocol (LACP)