Users Guide

ManualsBrandsDell ManualsComputer equipmentPowerEdge M IO Aggregator

231

232

233

234

235

236

237

238

239

240

Isolated Networks

This chapter describes the isolated networks commands in the Dell Networking OS.

io-aggregator isolated-network vlan

Enable the isolated-network functionality for a particular VLAN or a set of VLANs.

Syntax

[no] io-aggregator isolated-network vlan vlan-range

Parameters

isolated-

network

Specify an isolated network to be congured

vlan vlan-

range

Enter the keyword vlan followed by the member VLANs using VLAN IDs (separated

by commas), a range of VLAN IDs (separated by a hyphen), a single VLAN ID, or a

combination. For example: VLAN IDs (comma-separated): 3, 4, 6. Range (hyphen-

separated): 5-10. Combination: 3, 4, 5-10, 8.

Defaults Not congured.

Command Modes CONFIGURATION

Usage Information To add more VLANs into an isolated network, you can enter this same command at any later point. The

VLANs specied are appended to the existing set of VLANs. To remove a VLAN or a set of VLANs from an

isolated network, use the no form of command.

Supported Modes All Modes

Command History

Version Description

9.5(0.0) Supported on the FN I/O Aggregator.

9.5(0.0) Supported on the M I/O Aggregator.

Example

Dell(conf)#io-aggregator isolated-network vlan 5-10

show io-aggregator isolated-networks

Display the VLANs that are congured to be part of an isolated network on an Aggregator.