Users Guide

Field Description
Last Change Identies when the route was last changed or congured.
Example
Example (Summary)
Dell#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
Dell#show ip route static ?
| Pipe through a command
<cr>
Dell#show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.10.91.9, Te 1/2 1/0 3d2h
Dell#
show tcp statistics
View information on TCP trac through the switch.
Syntax
show tcp statistics
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The following describes the show tcp statistics cp command shown in the following example.
Field Description
Rcvd: Displays the number and types of TCP packets received by the switch.
• Total = total packets received
• no port = number of packets received with no designated port
0 checksum error... Displays the number of packets received with the following:
• checksum errors
• bad oset to data
• too short
329 packets... Displays the number of packets and bytes received in sequence.
17 dup... Displays the number of duplicate packets and bytes received.
0 partially... Displays the number of partially duplicated packets and bytes received.
7 out-of-order... Displays the number of packets and bytes received out of order.
230
IPv4 Routing