Users Guide

• Up at 100 Mb/s
• Down
• Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
Related Commands speed (for 1000/10000 interfaces) — sets the link speed to 1000, 10000, or auto-negotiate the speed.
remote-fault-signaling rx
Brings the interface up or down when a Remote Fault Indication (RFI) error is detected.
Syntax
remote-fault-signaling rx {on | off}
Parameters
on Brings the interface up when an RFI error is detected.
o Brings the interface down when an RFI error is detected.
Defaults ON.
Command Modes INTERFACE CONFIGURATION
Command History
Version 9.7(0.0) Introduced on the M I/O Aggregator.
Usage Information
By default, the M I/O Aggregator processes RFI errors transmitted by remote peers and brings down the
interface when an RFI error is detected.
Example
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
show cong (INTERFACE mode)
Displays the interface conguration.
Syntax
show config
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
Interfaces
197