Users Guide

Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information This CLI applies only to the Default VLAN.
To display information about a named VLAN, enter the show vlan command with the name parameter or
the show interfaces description command.
Related commands default vlan-id —Assigns a descriptive text string to the interface.
interface vlan — Congures a VLAN.
show vlan — Displays the current VLAN congurations on the switch.
negotiation auto
Enable auto-negotiation on an interface.
Syntax
negotiation auto
To disable auto-negotiation, enter no negotiation auto command.
Defaults Enabled.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
8.3.17.0 Supported on the M I/O Aggregator
Usage Information
The no negotiation auto command is only available if you rst manually set the speed of a port to
10Mbits or 100Mbits.
The negotiation auto command provides a mode option for conguring an individual port to forced-
master/forced slave once auto-negotiation is enabled.
If the mode option is not used, the default setting is slave. If you do not congure forced-master or forced
slave on a port, the port negotiates to either a master or a slave state. Port status is one of the following:
• Forced-master
• Force-slave
• Master
• Slave
• Auto-neg Error—typically indicates that both ends of the node are congured with forced-master or
forced-slave
Interfaces
195