Users Guide

MTU 2000, the Port Channel’s MTU values cannot be higher than 2100 for link MTU or 2000 bytes for
IP MTU.
When an interface is removed from a Port Channel with the no channel-member command, the
interface reverts to its conguration prior to joining the Port Channel.
An interface can belong to only one Port Channel.
You can add up to 16 interfaces to a Port Channel on the MXL switch. The interfaces can be located on
dierent line cards but must be the same physical type and speed (for example, all 10-Gigabit Ethernet
interfaces). However, you can combine 100/1000 interfaces and GE interfaces in the same Port Channel.
If the Port Channel contains a mix of interfaces with 100 Mb/s speed and 1000 Mb/s speed, the software
disables those interfaces whose speed does not match the speed of the rst interface congured and
enabled in the Port Channel. If that rst interface goes down, the Port Channel does not change its
designated speed; disable and re-enable the Port Channel or change the order of the channel members
conguration to change the designated speed. If the Port Channel contains a mix of interfaces with 100
Mb/s speed and 1000 Mb/s speed, the software disables those interfaces whose speed does not match the
speed of the rst interface congured and enabled in the Port Channel. If that rst interface goes down, the
Port Channel does not change its designated speed; disable and re-enable the Port Channel or change the
order of the channel members conguration to change the designated speed. For more information about
Port Channels, refer to the Dell Networking OS Conguration Guide.
Related Commands
interface port-channel — creates a Port Channel interface.
clear counters
Clear the counters used in the show interfaces commands for VLANs, and physical interfaces, or selected ones.
Syntax
clear counters interface
Defaults Without a specic interface specied, the command clears all interface counters.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port or number to clear
counters from a specied interface:
• For the management interface on the stack-unit, enter the keyword
managementethernet followed by slot/port information. The slot and port
range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed by a
number. Range: 1-128
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
180
Interfaces