Users Guide

On an M I/O Aggregator NPIV proxy gateway, an FCoE map is applied on fabric-facing FC ports and server-
facing Ethernet ports. Use the fcoe-map command to apply an FCoE map on an Ethernet port. Use the
fabric command to apply an FCoE map on an FC port.
An FCoE map consists of the following parameters: the dedicated FCoE VLAN for storage trac, the
destination SAN fabric (FC-MAP value), FCF priority, and the FIP keepalive (FKA) advertisement timeout.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in
Interface conguration mode.
NOTE: You cannot create fcoe-map in IOA mode. It can only be created in PMUX mode.
NOTE: In FCF F mode, you can create only one FCoE map. It doesn’t get created automatically. If
you try to create more than one map, an error message is displayed.
Related Commands
show fcoe-map— displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
feature fc
Enable feature fc with FPort functionality.
Syntax
feature fc fport domain-id range
Parameters
Range Enter the range from 1 to 239.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.7(0.0) Introduced on the M I/O Aggregator.
Usage Information Enable remote-fault-signaling rx off command in FCF FPort mode on interfaces connected to
the Compellent and MDF storage devices.
Example
Dell(conf)#feature fc fport domain-id
show fc alias
Display the congured alias.
Syntax
show fc alias [ZoneAliasName ]
Parameters
ZoneAliasName Enter the zone alias name to display the details.
Command Modes
• EXEC
• EXEC Privilege
FC FLEXIO FPORT
147