Users Guide

Command History
Version Description
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex
IO module.
Usage Information
An FCoE map is a template used to map FCoE and FC parameters in a converged fabric. An FCoE map is
used to virtualize upstream FC ports on an M I/O Aggregator with the PMUX module NPIV proxy gateway
so that they appear to downstream server CNA ports as FCoE forwarder (FCF) ports on an FCoE network.
When applied to FC and Ethernet ports on an NPIV proxy gateway, an FCoE map allows the switch to
operate as an FCoE-FC bridge between an FC SAN and an FCoE network by providing FCoE-enabled
servers and switches with the necessary parameters to log in to a SAN fabric.
On an M I/O Aggregator with the PMUX module NPIV proxy gateway, you cannot apply an FCoE map is
applied on fabric-facing FC ports and server-facing 10–Gigabit Ethernet ports.
An FCoE map consists of the following parameters: the dedicated FCoE VLAN used for storage trac, the
destination SAN fabric (FC-MAP value), FCF priority used by a server, and the FIP keepalive (FKA)
advertisement timeout.
In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must be unique. Use one
FCoE map to access one SAN fabric. You cannot use the same FCoE map to access dierent fabrics.
To remove an FCoE map from an Ethernet interface, enter the no fcoe-map map-name command in
Interface conguration mode.
Related Commands
show fcoe-map— displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
fka-adv-period
In an FCoE map, congure the time interval used to transmit FIP keepalive (FKA) advertisements.
M I/O Aggregator with the FC Flex IO module
Syntax
fka-adv-period seconds
Parameters
seconds Enter the time period (in seconds) used to send FIP keepalive messages to peer
devices. The range is from 8 to 90 seconds.
Defaults 8 seconds
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex
IO module.
Usage Information
To delete the FIP keepalive time period from an FCoE map, enter the no fka-adv-erpiod command.
FC Flex IO Modules
135