User's Manual

Unit Boot-Mode Next-Boot
------------------------------------------------
0 standalone standalone
Dell#
2. Change IOA mode to PMUX mode.
Dell(conf)# stack-unit 0 iom-mode programmable-mux
Where stack-unit 0 defines the default stack-unit number.
3. Delete the startup configuration file.
Dell# delete startup-config
4. Reboot the IOA by entering the reload command.
Dell# reload
5. Repeat the above steps for each member of the IOA in PMUX mode.
After system is up, you can see the PMUX mode status:
Dell#sh system stack-unit 0 iom-mode
Unit Boot-Mode Next-Boot
------------------------------------------------
0 programmable-mux programmable-mux
Dell#
The IOA is now ready for PMUX operations.
Configuring the Commands without a Separate User Account
Starting with Dell Networking OS version 9.3(0.0), you can configure the PMUX mode CLI
commands without having to configure a new, separate user profile. The user profile you
defined to access and log in to the switch is sufficient to configure the PMUX mode commands.
The IOA PMUX Mode CLI Commands section lists the PMUX mode CLI commands that you
can now configure without a separate user account.