User's Manual

Defaults
8 seconds
Command Modes
FCOE MAP
Command History
Version 9.3(0.0)
Related Commands
• fcoe-map
•
show fcoe-map
interface vlan
Create a dedicated VLAN to be used to send and receive Fibre Channel traffic over FCoE links.
Syntax
interface vlan vlan-id
Parameters
vlan-id = Enter a number as the VLAN Identifier. The range is 1 to
4094.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Version 9.3(0.0)
Usage Information
You must configure a separate FCoE VLAN for each fabric to which
FCoE traffic is forwarded.
When you apply an FCoE map to a server-facing Ethernet port, the
port is automatically configured as a tagged member of the FCoE
VLAN.
For more information about VLANs and the commands to configure
them, refer to the Virtual LAN (VLAN) Commands section of the
Layer 2 chapter.
Example (Single Range)
Dell(conf)#interface vlan 10
Dell(conf-if-vl-10)#
Related Commands
• fcoe-map
•
show fcoe-map
keepalive
Enable FIP keepalive message monitoring (if disabled).
Syntax
Keepalive
To remove FIP keepalive monitoring from an FCoE map, enter the
no
keepalive command.
Parameters
None
Defaults
Enabled on Ethernet and FC interfaces.
Command Modes
FCOE MAP
Command History
Version 9.3(0.0)
Usage Information
Use FIP keepalive (FKA) messaging to detect if the other FCoE
devices are reachable.
Related Command
• fcoe-map
•
show fcoe-map