User's Manual

Parameters
priority-bitmap = Enter the priority-bitmap range. The range
is from 1 to FF.
Defaults
0x8
Command Modes
PROTOCOL LLDP
Command History
Version 9.3(0.0)
fcoe-map
Configure the links between the server CNAs and a SAN fabric. Apply the FCoE map on a server-
facing Ethernet port.
Syntax
fcoe-map map-name
To remove an FCoE map from an Ethernet interface, enter the no
fcoe-map map-name command in Interface configuration mode.
Parameters
map-name = Enter a maximum of 32 alphanumeric characters.
Defaults
None for the MXL switch.
For the IOA, the following parameters are applied:
• Description: SAN_FABRIC
• Fabric-id: 1002
• Fcoe-vlan: 1002
• Fc-map: 0x0efc00
• Fcf-priority: 128
• Fka-adv-period: 8000mSec
• Keepalive: enable
•
Vlan priority: 3
Command Modes
•
CONFIGURATION
•
INTERFACE
Command History
Version 9.3(0.0)
Usage Information
In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN
parameters must be unique. Use one FCoE map to access one SAN
fabric. You cannot use the same FCoE map to access different
fabrics.
Related Commands
• interface fibrechannel
•
show fcoe-map
fka-adv-period
Configure the time used to transmit FIP keepalive (FKA) advertisements.
Syntax
fka-adv-period seconds
To delete the FIP keepalive time period from an FCoE map, enter the
no fka-adv-period command.
Parameters
Seconds = Enter the time period (in seconds) used to send FIP
keepalive messages to peer devices. The range is from 8 to 90
seconds.