User's Manual

Related Commands
• fcoe-map
• show fcoe-map
fabric
Apply an FCoE map on a fabric-facing Fibre Channel (FC) port.
Syntax
Fabric map-name
Parameters
map-name
= Enter a maximum of 32 alphanumeric characters.
To remove an FCoE map from an FC interface, enter the no fabric
map-name command in Interface Configuration mode.
Defaults
None
Command Modes
INTERFACE FIBRE_CHANNEL
Command History
Version 9.3(0.0)
Usage Information
After you apply an FCoE map on an FC interface, when you enable the
port (no shutdown), the FC port will login to the FC equipment it is
connected to; after login success, advertisements are sent to the
server ports.
Related Commands
• fcoe-map
• interface fibrechannel
•
show fcoe-map
fabric-id vlan
Configure the association between the dedicated VLAN (used to carry FCoE traffic between
servers and a SAN) and the fabric storage arrays.
Syntax
fabric-id fabric-num vlan vlan-id
To remove a fabric-VLAN association from an FCoE map, enter the no
fabric-id vlan command.
Parameters
• fabric-id fabric-num = Enter a fabric ID number that is
the same as the ID number of the dedicated VLAN. The range is
from 1 to 4094.
• vlan vlan-id = Enter the ID number of the dedicated
VLAN.
Defaults
None
Command Modes
FCOE MAP
Command History
Version 9.3(0.0)
Usage Information
The fabric and VLAN ID numbers must be the same. However, in each
FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters
must be unique.
You must first create a VLAN and then specify the configured VLAN ID
in the fabric-id vlan command. Otherwise, the following error
message displays:
FTOS(conf-fcoe-f)#fabric-id 10 vlan 10
% Error: Vlan 10 does not exist