Reference Guide

Control and Monitoring | 73
ssh-peer-stack-unit
Open an SSH connection to the peer stack-unit.
Syntax
ssh-peer-stack-unit [-l username]
Parameters
Defaults
Not configured.
Command Modes
EXEC Privilege
Command
History
telnet
Connect through Telnet to a server. The Telnet client and server in FTOS supports IPv4 connections.
You can establish a Telnet session directly to the router, or a connection can be initiated from the router.
Syntax
telnet {host | ip-address} [/source-interface]
Parameters
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
Telnet to link-local addresses is not supported.
-l username
(OPTIONAL) Enter the keyword -l followed by your username.
Default: The username associated with the terminal.
Version 8.3.17.0 Supported on M I/O Aggregator
host
Enter the name of a server.
ip-address
Enter the IPv4 address in dotted decimal format of the server.
/source-interface (OPTIONAL) Enter the keywords /source-interface followed by the interface
information to include the interface’s IP address.
Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1
to 4094.
Version 8.3.17.0 Supported on M I/O Aggregator