Reference Guide

48 | Control and Monitoring
www.dell.com | support.dell.com
Defaults
See parameters above.
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When you enter the ping command without specifying an IP address (Extended Ping), you are
prompted for a target IP address, a repeat count, a datagram size (up to 1500 bytes), a timeout in
seconds, and for Extended Commands. For information on the ICMP message codes that return from a
ping command, refer to Chapter 26, Internet Control Message Protocol (ICMP) Message Types.
Figure 5-3. ping (IPv4) Command Example
reload
Reboot FTOS.
Syntax
reload
Command Modes
EXEC Privilege
Command
History
Usage
Information
If there is a change in the configuration, FTOS prompts you to save the new configuration. Or you can
save your running configuration with the copy running-config command.
Related
Commands
s
sweep-interval
Enter the incremental value for sweep size.
1-15308 seconds
ointerface
Enter the outgoing interface for multicast packets.
• Enter the IP address in A.B.C.D format
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#ping 172.31.1.255
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds:
Reply to request 1 from 172.31.1.208 0 ms
Reply to request 1 from 172.31.1.216 0 ms
Reply to request 1 from 172.31.1.205 16 ms
:
:
Reply to request 5 from 172.31.1.209 0 ms
Reply to request 5 from 172.31.1.66 0 ms
Reply to request 5 from 172.31.1.87 0 ms
FTOS#
Version 8.3.17.0 Supported on M I/O Aggregator
reset stack-unit Resets any designated stack member except the management unit.