Reference Guide

File Management | 37
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
You must reload FTOS after executing this command. Use the command upgrade system stack-unit to
copy FTOS from the management unit to one or more stack members.
Example
Figure 4-17. upgrade system Command Example
flash
After entering this keyword you can either follow it with the location of the source file in this
form:
//filepath, or press Enter to launch a prompt sequence.
usbflash
After entering this keyword you can either follow it with the location of the source file in this
form:
//filepath, or press Enter to launch a prompt sequence..
A
Enter this keyword to upgrade the bootflash partition A
B
Enter this keyword to upgrade the bootflash partition B
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#upgrade system ?
flash: Copy from flash file system (flash://filepath)
ftp: Copy from remote file system, IPv4 or IPv6, (ftp:/
/userid:password@hostip/filepath)
scp: Copy from remote file system, IPv4 or IPv6, (scp:/
/userid:password@hostip/filepath)
stack-unit Sync image to the stack-unit
tftp: Copy from remote file system, IPv4 or IPv6, (tftp:/
/hostip/filepath)
usbflash: Copy from usbflash file system (usbflash://
filepath)
FTOS#