Reference Guide

238 | Uplink Failure Detection (UFD)
www.dell.com | support.dell.com
debug uplink-state-group
Enable debug messages for events related to a specified uplink-state group or all groups.
Syntax
debug uplink-state-group [group-id]
To turn off debugging event messages, use the no debug uplink-state-group [group-id] command.
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
group-id Enables debugging on the specified uplink-state group. Valid group-id values
are 1 to 16.
Version 8.3.17.0 Supported on M I/O Aggregator