Reference Guide

182 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
debug lacp
Debug LACP (events).
Syntax
debug lacp [events | pdu interface [in | out]]
To disable LACP debugging, use the no debug lacp [events | pdu interface [in | out]] command.
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
show lacp
Displays the LACP matrix.
Syntax
show lacp port-channel-number [sys-id | counters]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
events (OPTIONAL) Enter the keyword events to debug LACP event information.
pdu in | out (OPTIONAL) Enter the keyword pdu to debug LACP Protocol Data Unit
information. Optionally, enter an
in or out parameter to:
• Receive enter
in
• Transmit enter out
interface in | out
Enter the following keywords and slot/port or number information:
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
Version 8.3.17.0 Supported on M I/O Aggregator
port-channel-number
Enter a port-channel number:
Range: 1 to 128
sys-id (OPTIONAL) Enter the keyword sys-id and the value that identifies a
system.
counters (OPTIONAL) Enter the keyword counters to display the LACP counters.
Version 8.3.17.0 Supported on M I/O Aggregator