Reference Guide

172 | IPv4 Routing
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 12-11. show ip route summary and show ip route static Command Examples
Version 8.3.17.0 Supported on M I/O Aggregator
Table 12-7. show ip route all Command Example Fields
Field Description
(undefined) Identifies the type of route:
•
C = connected
•
S = static
•
R = RIP
•
B = BGP
•
IN = internal BGP
•
EX = external BGP
•
LO = Locally Originated
•
O = OSPF
•
IA = OSPF inter area
•
N1 = OSPF NSSA external type 1
•
N2 = OSPF NSSA external type 2
•
E1 = OSPF external type 1
•
E2 = OSPF external type 2
•
i = IS-IS
•
L1 = IS-IS level-1
•
L2 = IS-IS level-2
•
IA = IS-IS inter-area
•
* = candidate default
•
> = non-active route
• + = summary routes
Destination Identifies the route’s destination IP address.
Gateway Identifies whether the route is directly connected and on which interface the route is
configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
FTOS#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
FTOS#show ip route static ?
| Pipe through a command
<cr>
FTOS#show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.10.91.9, Te 1/2 1/0 3d2h
FTOS#