Reference Guide

168 | IPv4 Routing
www.dell.com | support.dell.com
show ip management-route
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 12-7. show ip management route Command Example
show ip multicast-cam stack-unit
Displays content-addressable memory (CAM) entries.
Syntax
show ip multicast-cam stack-unit 0-5 port-set pipe-number [ip-address mask [longer-prefixes] |
detail | member-info | summary]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number
of active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Version 8.3.17.0 Supported on M I/O Aggregator
FTOS#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
FTOS#
0-5
Enter the stack-unit ID, from 0 to 5.
pipe-number
Enter the number of the Port-Pipe number.
Range: 0 to 0
ip-address mask
[
longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that route
only.
Enter the keyword
longer-prefixes to view routes with a common prefix.
detail Enter the keyword detail to display the group index ID used by the ecmp routes in
the CAM.