Reference Guide

Interfaces | 153
Example
Figure 11-28. show range Command Example
Related
Commands
show tdr
Displays the TDR test results.
Syntax
show tdr interface
Parameters
Defaults
none
Command Modes
EXEC
Command
History
Example
Figure 11-29. show tdr tengigabitethernet Command Example
Table 11-9. TDR Test Status
Usage
Information
If the TDR test has not been run, an error messages is generated:
%Error: Please run the TDR test first
Note that TDR test is supported only on 10GbaseT interfaces.
FTOS(conf-if-range-te-0/16)#show range
interface tengigabitethernet 0/16
FTOS(conf-if-range-te-0/16)#
show ip interface Displays Layer 3 information about the interfaces.
interface
Enter the keyword TenGigabitEthernet followed by the slot/port information
for the 100/1000/10GbaseT Ethernet interface.
Version 8.3.17.0 Supported on M I/O Aggregator
Status Definition
OK Status: Terminated
TDR test is complete, no fault is detected on the
cable, and the test is terminated
Length: 92 (+/- 1) meters, Status: Shorted
A short is detected on the cable. The location, in
this example is 92 meters, of the short is accurate
to plus or minus one meter.
Length: 93 (+/- 1) meters, Status: Open
An opening is detected on the cable. The location,
in this example is 93 meters, of the open is
accurate to plus or minus one meter.
Status: Impedance Mismatch There is an impedance mismatch in the cables.
FTOS#show tdr tengigabitethernet 1/1
Time since last test: 00:00:02
Pair A, Length: OK Status: Terminated
Pair B, Length: 92 (+/- 1) meters, Status: Short
Pair C, Length: 93 (+/- 1) meters, Status: Open
Pair D, Length: 0 (+/- 1) meters, Status: Impedance Mismatch