Reference Guide

138 | Interfaces
www.dell.com | support.dell.com
name
Assign a name to the Default VLAN.
Syntax
name vlan-name
To remove the name from the VLAN, use the no name command.
Parameters
Defaults
Not configured.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
This CLI applies only to the Default VLAN.
To display information about a named VLAN, enter the show vlan command with the name parameter
or the show interfaces description command.
Related
Commands
m Change the view from a single interface to all interfaces on the stack unit or visa-versa.
c Refresh the view.
b Change the counters displayed from Packets on the interface to Bytes.
r Change the [delta] column from change in the number of packets/bytes in the last interval to
rate per second.
l Change the view to next interface on the stack unit, or if in the stack unit mode, the next
stack unit in the chassis.
a Change the view to the previous interface on the stack unit, or if the stack unit mode, the
previous stack unit in the chassis.
T Increase the screen refresh rate.
t Decrease the screen refresh rate.
q Return to the CLI prompt.
Table 11-2. monitor Command Menu Options
Key Description
vlan-name
Enter up to 32 characters as the name of the VLAN.
Version 8.3.17.0 Supported on M I/O Aggregator
default vlan-id Assigns a descriptive text string to the interface.
interface vlan Configures a VLAN.
show vlan Displays the current VLAN configurations on the switch.