Owner`s manual

78 | Data Center Bridging (DCB)
www.dell.com | support.dell.com
This section contains examples of DCB input and output policies applied on an interface.
In the example shown in Figure 5-15 for an Aggregator:
• Incoming SAN traffic is configured for priority-based flow control.
• Outbound LAN, IPC, and SAN traffic is mapped into three ETS priority groups and configured for
enhanced traffic selection (bandwidth allocation and scheduling).
• One lossless queue is used.
Total DCBX Frame errors Number of DCBx frames with errors received.
Total DCBX Frames
unrecognized
Number of unrecognizable DCBx frames received.
PFC TLV Statistics:
Input PFC TLV pkts Number of PFC TLVs received.
Output PFC TLV pkts Number of PFC TLVs transmitted.
Error PFC pkts Number of PFC error packets received.
PFC Pause Tx pkts Number of PFC pause frames transmitted.
PFC Pause Rx pkts Number of PFC pause frames received.
PG TLV Statistics:
Input PG TLV pkts Number of PG TLVs received.
Output PG TLV pkts Number of PG TLVs transmitted.
Error PG TLV pkts Number of PG error packets received.
Application Priority TLV Statistics:
Input Appln Priority TLV pkts Number of Application TLVs received.
Output Appln Priority TLV pkts Number of Application TLVs transmitted.
Error Appln Priority TLV pkts Number of Application TLV error packets received.
Table 5-5. show interface dcbx detail Command Description
Field Description