Owner`s manual

130 | Interfaces
www.dell.com | support.dell.com
To view which interfaces are enabled for Layer 3 data transmission use the show ip interfaces brief command
in EXEC Privilege mode. In Figure 9-2, the TenGigabitEthernet interface 1/5 is in Layer 3 mode because
an IP address has been assigned to it and the interface’s status is operationally up.
Figure 9-2. show ip interfaces brief Command Example (Partial)
To view only configured interfaces use the show interfaces configured command in EXEC Privilege mode.
To determine which physical interfaces are available, use the
show running-config command in EXEC mode.
This command displays all physical interfaces available on the switch (Figure 9-3).
Figure 9-3. show running-config Command Example (Partial)
FTOS#show ip interface brief
Interface IP-Address OK Method Status Protocol
TenGigabitEthernet 1/1 unassigned NO None up down
TenGigabitEthernet 1/2 unassigned NO None up down
TenGigabitEthernet 1/3 unassigned NO None up down
TenGigabitEthernet 1/4 unassigned NO None up down
TenGigabitEthernet 1/5 unassigned YES None up up
TenGigabitEthernet 1/6 unassigned NO None up down
TenGigabitEthernet 1/7 unassigned NO None up down
TenGigabitEthernet 1/8 unassigned NO None up down
TenGigabitEthernet 1/9 unassigned NO None up down
--More--
FTOS#show running config
Current Configuration ...
! Version E8-3-17-38
! Last configuration change at Tue Jul 24 20:48:55 2012 by default
!
boot system stack-unit 1 primary tftp://10.11.9.21/dv-m1000e-2-b2
boot system stack-unit 1 default system: A:
boot system gateway 10.11.209.62
!
redundancy auto-synchronize full
!
service timestamps log datetime
!
hostname FTOS
!
username root password 7 d7acc8a1dcd4f698 privilege 15
mac-address-table aging-time 300
!
stack-unit 1 provision I/O-Aggregator
!
stack-unit 1 port 33 portmode quad
!
stack-unit 1 port 37 portmode quad
--More--