Deployment Guide

Example of the show interface ets detail Command
Dell# show interfaces tengigabitethernet 0/4 ets detail
Interface TenGigabitEthernet 0/4
Max Supported TC Groups is 4
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
TC-grp Priority# Bandwidth TSA
0 0,1,2,3,4,5,6,7 100% ETS
1 0% ETS
2 0% ETS
3 0% ETS
4 0% ETS
5 0% ETS
6 0% ETS
7 0% ETS
Remote Parameters:
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
PG-grp Priority# Bandwidth TSA
0 0,1,2,3,4,5,6,7 100% ETS
1 0% ETS
2 0% ETS
3 0% ETS
4 0% ETS
5 0% ETS
6 0% ETS
7 0% ETS
Oper status is init
ETS DCBX Oper status is Down
State Machine Type is Asymmetric
Conf TLV Tx Status is enabled
Reco TLV Tx Status is enabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Reco TLV Pkts, 0 Output Reco TLV Pkts, 0 Error Reco TLV Pkts
The following table describes the show interface ets detail command elds.
Field
Description
Interface Interface type with stack-unit and port number.
Max Supported TC
Group
Maximum number of priority groups supported.
Number of Trac
Classes
Number of 802.1p priorities currently congured.
Admin mode ETS mode: on or o.
When on, the scheduling and bandwidth allocation congured in an ETS output policy or received in a DCBx TLV
from a peer can take eect on an interface.
Admin Parameters ETS conguration on local port, including priority groups, assigned dot1p priorities, and bandwidth allocation.
62 Data Center Bridging (DCB)