Deployment Guide
2 Apply the FCoE and FC fabric congurations in an FCoE map to the port. Repeat this step to apply an FCoE map to more than one
FC port.
INTERFACE FIBRE_CHANNEL mode
fabric map-name
Dell# interface fi 0/9
Dell(config-if-fc-0/9)# fabric SAN_FABRIC_A
3 Enable the port for FC transmission.
INTERFACE FIBRE_CHANNEL mode
no shutdown
Important Points to Remember
You can apply a DCB or FCoE map to a range of Ethernet or Fibre Channel interfaces by using the interface range command; for
example:
Enter the keywords interface range followed by an interface type and port range. A port range must contain spaces before and after
the dash. Separate each interface type and port range with a space, comma, and space as shown in the preceding examples.
Sample Conguration
1 Congure a DCB map with PFC and ETS settings:
Dell(config)# dcb-map SAN_DCB_MAP
Dell(config-dcbx-name)# priority-group 0 bandwidth 60 pfc off
Dell(config-dcbx-name)# priority-group 1 bandwidth 20 pfc on
Dell(config-dcbx-name)# priority-group 2 bandwidth 20 pfc on
Dell(config-dcbx-name)# priority-group 4 strict-priority pfc off
Dell(conf-dcbx-name)# priority-pgid 0 0 0 1 2 4 4 4
2 Apply the DCB map on a downstream (server-facing) Ethernet port:
Dell(config-if-te-0/0)#dcb-map SAN_DCB_MAP
3 Create the dedicated VLAN to be used for FCoE trac:
Dell(conf)#interface vlan 1002
4 Congure an FCoE map to be applied on downstream (server-facing) Ethernet and upstream (core-facing) FC ports:
Dell(config)# fcoe-map SAN_FABRIC_A
Dell(config-fcoe-name)# fabric-id 1002 vlan 1002
Dell(config-fcoe-name)# description "SAN_FABRIC_A"
Dell(config-fcoe-name)# fc-map 0efc00
Dell(config-fcoe-name)# keepalive
NPIV Proxy Gateway
327