Deployment Guide

member zonename
Example of Creating Zonesets
Dell(conf)#fc zoneset zs1
Dell(conf-fc-zoneset-zs1)#member z1
Dell(conf-fc-zoneset-zs1)#
Dell(conf-fc-zoneset-zs1)#exit
Dell(conf-fc-zoneset-zs1)#
Activating a Zoneset
Activating a zoneset makes the zones within it eective.
On a switch, only one zoneset can be active. Any changes in an activated zoneset do not take eect until it is re-activated.
By default, the fcoe-map fabric map-namedoes not have any active zonesets.
1 Enter enter the fc-fabric command in fcoe-map to active or de-activate the zoneset.
Dell(conf-fcoe-map)#fc-fabric
Example:
Dell(conf)#fcoe-map map
Dell(conf-fcoe-map)#fc-fabric
Dell(conf-fmap-map-fcfabric)#active-zoneset set
Dell(conf-fmap-map-fcfabric)#no active-zoneset?
active-zoneset
Dell(conf-fmap-map-fcfabric)#no active-zoneset ?
<cr>
Dell(conf-fmap-map-fcfabric)#no active-zoneset
2 View the active zoneset.
show fc zoneset active
Displaying the Fabric Parameters
To display information on switch-wide and interface-specic fabric parameters, use the show commands in the following table.
Examples of these show commands follow this table.
Command
Description
show cong Displays the fabric parameters.
show fcoe-map Displays the fcoe-map.
show fc ns switch Display all the devices in name server database of the switch.
show fc ns switch
brief
Display all the devices in name server database of the switch - brief version.
show fc zoneset Displays the zoneset.
show fc zoneset
active
Displays the active zoneset.
show fc zone Displays the congured zone.
show fc alias Displays the congured alias.
show fc switch Displays the FC Switch mode and world wide name.
Example of the show config Command
Dell(conf-fcoe-SAN_FABRIC)#show config
!
FC FLEXIO FPORT
315