Manualshelf

Deployment Guide

ManualsBrandsDell ManualsComputer equipmentPowerEdge M IO Aggregator
301302303304305306307308309310
Conguring Switch Mode to FCF Port Mode
To congure switch mode to Fabric services, use the following commands.
1 Congure Switch mode to FCF Port.
CONFIGURATION mode
feature fc fport domain id 2
NOTE
: Enable remote-fault-signaling rx off command in FCF FPort mode on interfaces connected to the
Compellent and MDF storage devices.
2 Create an FCoE map with the parameters used in the communication between servers and a SAN fabric.
CONFIGURATION mode
fcoe-map map-name
3 Congure the association between the dedicated VLAN used to carry FCoE trac between servers and a SAN, and the fabric where
the desired storage arrays are installed.
310
FC FLEXIO FPORT