Deployment Guide

privilege mode {level level command | reset command}
Congure the following required and optional parameters:
• mode: enter a keyword for the modes (exec, configure, interface, line, route-map, or router)
• level level: the range is from 0 to 15. Levels 0, 1, and 15 are pre-congured. Levels 2 to 14 are available for custom
conguration.
• command: an Dell CLI keyword (up to ve keywords allowed).
• reset: return the command to its default privilege mode.
To view the conguration, use the show running-config command in EXEC Privilege mode.
The following example shows a conguration to allow a user john to view only EXEC mode commands and all snmp-server commands.
Because the snmp-server commands are enable level commands and, by default, found in CONFIGURATION mode, also assign the
launch command for CONFIGURATION mode, configure, to the same privilege level as the snmp-server commands.
Line 1: The user john is assigned privilege level 8 and assigned a password.
Line 2: All other users are assigned a password to access privilege level 8.
Line 3: The configure command is assigned to privilege level 8 because it needs to reach CONFIGURATION mode where the snmp-
server commands are located.
Line 4: The snmp-server commands, in CONFIGURATION mode, are assigned to privilege level 8.
Example of Conguring a Custom Privilege Level
Dell(conf)#username john privilege 8 password john
Dell(conf)#enable password level 8 notjohn
Dell(conf)#privilege exec level 8 configure
Dell(conf)#privilege config level 8 snmp-server
Dell(conf)#end
Dell#show running-config
Current Configuration ...
!
hostname FTOS
!
enable password level 8 notjohn
enable password FTOS
!
username admin password 0 admin
username john password 0 john privilege 8
!
The following example shows the Telnet session for user john. The show privilege command output conrms that john is in privilege
level 8. In EXEC Privilege mode, john can access only the commands listed. In CONFIGURATION mode, john can access only the snmp-
server
commands.
Example of Privilege Level Login and Available Commands
apollo% telnet 172.31.1.53
Trying 172.31.1.53...
Connected to 172.31.1.53.
Escape character is '^]'.
Login: john
Password:
Dell#show priv
Current privilege level is 8
Dell#?
configure Configuring from terminal
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from the EXEC
no Negate a command
show Show running system information
Security
193