Deployment Guide
can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-address-table static
multicast-mac-address vlan vlan-id output-range interface command.
Enhanced Control of Remote Fault Indication
Processing
By default, the M I/O Aggregator module processes RFI errors transmitted by remote peers and brings down the interface when an RFI
error is detected.
You must enter the interface conguration mode before conguring Remote Fault Indication (RFI).
You can use the following CLI commands to enable or disable processing of received RFI events:
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
The default is "remote-fault-signaling rx on".
Interfaces 125