Deployment Guide

EXEC Privilege mode
show interfaces [interface] status
2 Determine the remote interface status.
EXEC mode
EXEC Privilege mode
[Use the command on the remote system that is equivalent to the above command.]
3 Access CONFIGURATION mode.
EXEC Privilege mode
config
4 Access the port.
CONFIGURATION mode
interface interface slot/port
5 Set the local port speed.
INTERFACE mode
speed {100 | 1000 | 10000 | auto}
6 Optionally, set full- or half-duplex.
INTERFACE mode
duplex {half | full}
7 Disable auto-negotiation on the port. If the speed is set to 1000, you do not need to disable auto-negotiation.
INTERFACE mode
no negotiation auto
8 Verify conguration changes.
INTERFACE mode
show config
NOTE
: The show interfaces status command displays link status, but not administrative status. For link and administrative status,
use the show ip interface [interface | brief] [configuration] command.
show interface status Command Example:
Dell#show interfaces status
Port Description Status Speed Duplex Vlan
Te 0/1 Down Auto Auto --
Te 0/2 Down Auto Auto --
Te 0/3 Down Auto Auto --
Te 0/4 Down Auto Auto --
Te 0/5 Down Auto Auto --
Te 0/6 Down Auto Auto --
Te 0/7 Down Auto Auto --
Te 0/8 Down Auto Auto --
Te 0/9 Down Auto Auto --
Te 0/10 Down Auto Auto --
Te 0/11 Down Auto Auto --
Te 0/12 Down Auto Auto --
Interfaces
121