Deployment Guide

Adding an Interface to an Untagged VLAN
To move an untagged interfaces from the default VLAN to another VLAN, use the vlan untagged command as shown in the below
gure.
Dell(conf)# interface tengigabit 0/16
Dell(conf-if-te-0/16)# vlan untagged 4
Dell(conf-if-te-0/16)# exit
Dell(conf)# exit
Dell#00:23:49: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from console
Dell# show vlan id 4
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary,
C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged, C - CMC tagged
NUM Status Description Q Ports
4 Active U Po1(Te 0/16)
T Po128(Te 0/33,39,51,56)
T Te 0/1-15,17-32
Dell#
VLAN Conguration on Physical Ports and Port-Channels
Unlike other Dell Networking OS platforms, IOA allows VLAN congurations on port and port-channel levels. This allows you to assign
VLANs to a port/port-channel.
NOTE
: In PMUX mode, in order to avoid loops, only disjoint VLANs are allowed between the uplink ports/uplink LAGs and uplink-
to-uplink switching is disabled.
1 Initialize the port with congurations such as admin up, portmode, and switchport.
Dell#configure
Dell(conf)#int tengigabitethernet 0/1
Dell(conf-if-te-0/1)#no shutdown
Dell(conf-if-te-0/1)#portmode hybrid
Dell(conf-if-te-0/1)#switchport
2 Congure the tagged VLANs 10 through 15 and untagged VLAN 20 on this port.
Dell(conf-if-te-0/1)#vlan tagged 10-15
Dell(conf-if-te-0/1)#vlan untagged 20
Dell(conf-if-te-0/1)#
3 Show the running congurations on this port.
Dell(conf-if-te-0/1)#show config
!
interface TenGigabitEthernet 0/1
portmode hybrid
switchport
vlan tagged 10-15
vlan untagged 20
no shutdown
Dell(conf-if-te-0/1)#end
Dell#
Interfaces
109