Configuration manual

protocol lldp
2. Enable LLDP.
PROTOCOL LLDP mode
no disable
Disabling and Undoing LLDP
To disable or undo LLDP, use the following command.
• Disable LLDP globally or for an interface.
disable
To undo an LLDP configuration, precede the relevant command with the keyword no.
Advertising TLVs
You can configure the system to advertise TLVs out of all interfaces or out of specific interfaces.
• If you configure the system globally, all interfaces send LLDPDUs with the specified TLVs.
• If you configure an interface, only the interface sends LLDPDUs with the specified TLVs.
• If you configure LLDP both globally and at interface level, the interface level configuration overrides
the global configuration.
To advertise TLVs, use the following commands.
1. Enter LLDP mode.
CONFIGURATION or INTERFACE mode
protocol lldp
2. Advertise one or more TLVs.
PROTOCOL LLDP mode
advertise {dcbx-appln-tlv | dcbx-tlv | dot3-tlv | interface-port-desc |
management-tlv | med }
Include the keyword for each TLV you want to advertise.
• For management TLVs: system-capabilities, system-description.
• For 802.1 TLVs: port-protocol-vlan-id, port-vlan-id.
• For 802.3 TLVs: max-frame-size.
• For TIA-1057 TLVs:
– guest-voice
– guest-voice-signaling
– location-identification
– power-via-mdi
– softphone-voice
– streaming-video
– video-conferencing
240
PMUX Mode of the IO Aggregator