Configuration manual

Multicast peer-routing timeout: 150 seconds
Dell#
5. Configure the secondary VLT.
NOTE: Repeat steps from 1 through 4 on the secondary VLT, ensuring you use the different
backup destination and unit-id.
Dell#show vlt brief
VLT Domain Brief
------------------
Domain ID: 1
Role: Secondary
Role Priority: 32768
ICL Link Status: Up
HeartBeat Status: Up
VLT Peer Status: Up
Local Unit Id: 1
Version: 6(2)
Local System MAC address: f8:b1:56:0e:b1:7f
Remote System MAC address: 00:01:e8:e1:e1:c3
Configured System MAC address: 00:01:09:06:06:06
Remote system version: 6(2)
Delay-Restore timer: 90 seconds
Peer-Routing : Disabled
Peer-Routing-Timeout timer: 0 seconds
Multicast peer-routing timeout: 150 seconds
Dell#
Dell#show vlt detail
Local LAG Id Peer LAG Id Local Status Peer Status
Active VLANs
------------------- ------------ ----------- ----------
128 128 UP UP 1
Dell#
6. Show the running configurations on this port-channel.
Dell(conf-if-po-128)#show config
!
interface Port-channel 128
portmode hybrid
switchport
vlan tagged 10-15
vlan untagged 20
shutdown
Dell(conf-if-po-128)#end
Dell#
7. Show the VLAN configurations.
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P
- Primary, C - Community, I - Isolated
O - Openflow
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
NUM Status Description Q Ports
* 1 Active U Te 0/33
10 Active T Po128(Te 0/41-42)
T Te 0/1
PMUX Mode of the IO Aggregator
231