Concept Guide

• For MIOA for M1000e chassis devices, FN410S SKU and FN410T SKU FN IOA for FX2 chassis
devices in programmable multiplex mode, or FN MXL devices screen proceed to the Network
Settings screen.
Configuring Combo Port Settings (Initial Setup Wizard)
On the Combo Port Settings screen of the Initial Setup Wizard, you can configure ports 9 and 10 in
FN2210S SKU FN IOA for FX2 chassis devices to work either as Ethernet ports or Fibre Channel ports.
Ethernet ports handle common traffic. Fibre Channel ports connect to a Storage Area Network (SAN).
NOTE: This screen does not apply for MIOA for M1000e chassis devices, FN410S SKU and FN410T
SKU FN IOA for FX2 chassis devices in Programmable Multiplex mode, or FN MXL devices.
1. If not already done, from the Mode Settings screen, click Next.
The Combo Port Settings screen appears.
2. Make one of the following selections:
• Ethernet
• Fibre Channel
3. Click Next and proceed to the Network Settings screen.
Configuring Network Settings
On the Mode Settings screen of the Initial Setup Wizard, you configure the IP address of the Management
Interface in the I/O Aggregator module.
Make sure that the configured IP address is in the same subnet as the management device.
1. If not already done, from the Mode Settings screen, click Next.
The Network Settings screen appears.
2. In the IP Address Source field, select Static IP or Dynamic IP.
The IP Version, IP Address, Subnet Mask, and Gateway settings appear by default.
3. Click Next and proceed to the Credentials screen.
Configuring Credentials
On the Credentials screen of the Initial Setup Wizard, you configure the user name and password to log
on to the switch interface.
1. If not already done, from the Network Settings screen, click Next.
The Credentials screen appears.
2. In the User Name field, enter a user name. The minimum user name length is one alphanumeric
character and the maximum user name length is 63 alphanumeric characters.
3. In the Password and Re-enter Password fields, enter the password. The minimum password length is
one alphanumeric character and the maximum password length is 32 alphanumeric characters.
4. In the Enable Password and Re-enter Password fields, enter the password to enter the Enable mode
on the switch. The minimum password length is one alphanumeric character and the maximum
password length is 32 alphanumeric characters.
5. Click Next and proceed to the SNMP Settings screen.
9