Command Line Reference Guide

6
u-Boot
All commands in this chapter are in u-Boot mode. These commands are supported on the Dell
Networking Aggregator only.
To access this mode, hit Esc key when the following line appears on the console during a system boot:
Hit Esc key to interrupt autoboot:
You enter u-Boot immediately, as indicated by the BOOT_USER# prompt.
NOTE: Only the most frequently used commands available in uBoot mode are described in this
chapter.
In uBoot mode, you cannot use the Tab key for command completion.
boot change
Change the operating system boot parameters.
Syntax
boot change [primary | secondary | default]
Command
Modes
• uBoot
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
boot selection
Change the ROM bootstrap bootflash partition.
Syntax
boot selection[a | b]
Command
Modes
• uBoot
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
u-Boot
89