Command Line Reference Guide

Defaults Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP
port = 33434
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
When you enter the traceroute command without specifying an IP address
(Extended Traceroute), you are prompted for a target and source IP address,
timeout in seconds (default is 5), a probe count (default is 3), minimum TTL (default
is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the
default setting for those parameters, press the ENTER key.
Example (IPv4)
Dell#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server
(10.11.0.1) [OK]
Type Ctrl-C to abort.
---------------------------------------------------------------
------------------
---------
Tracing the route to www.force10networks.com (10.11.84.18), 30
hops max, 40 byte
packets
---------------------------------------------------------------
------------------
---------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000
ms 001.000 ms
001.000 ms
3 fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms
000.000 ms 000.000
ms
4 www.force10networks.com (10.11.84.18) 000.000 ms 000.000 ms
000.000 ms
Dell#
Related
Commands
ping — Tests the connectivity to a device.
undebug all
Disable all debug operations on the system.
Syntax
undebug all
Defaults none
Command
Modes
• EXEC Privilege
Control and Monitoring
87