Command Line Reference Guide

ssh-peer-stack-unit

Open an SSH connection to the peer stack-unit.

Syntax

ssh-peer-stack-unit [-| username]

Parameters

-| username (OPTIONAL) Enter the keyword -| followed by your

username.

Default: The username associated with the terminal.

Defaults Not configured.

Command

Modes

• EXEC Privilege

Command

History

Version 8.3.17.0 Supported on the M I/O Aggregator.

telnet

Connect through Telnet to a server. The Telnet client and server in Dell Networking OS support IPv4 and

IPv6 connections. You can establish a Telnet session directly to the router or a connection can be

initiated from the router.

Syntax

telnet {host | ip-address [/source-interface]

Parameters

host Enter the name of a server.

ip-address Enter the IPv4 address in dotted decimal format or the IPv6

address in the x:x:x:x::x format of the server.

NOTE: The :: notation specifies successive hexadecimal

fields of zeros. Only one occurrence of this notation is

permitted in an IPv6 address.

source-

interface

(OPTIONAL) Enter the keywords /source-interface then

the interface information to include the source interface.

Enter the following keywords and slot/port or number

information:

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

• For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Defaults Not configured.

Control and Monitoring