Command Line Reference Guide

Example
(Command)
Dell#show revision
-- Stack unit 1 --
IOM SYSTEM CPLD : 1
Dell#
show server-interfaces
Displays server port information.
Syntax
show server-interfaces{brief|detail}
Command
Modes
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example (brief
Command)
Dell#show server-interfaces brief
---------------- show server ports brief ---------------------
Interface OK Status Protocol Description
TenGigabitEthernet 0/1 YES up up
TenGigabitEthernet 0/2 YES up up
TenGigabitEthernet 0/3 YES up up
TenGigabitEthernet 0/4 NO up down
TenGigabitEthernet 0/5 YES up up
TenGigabitEthernet 0/6 NO up down
TenGigabitEthernet 0/7 YES up up
TenGigabitEthernet 0/8 NO up down
----------------------------------- show lacp
---------------------------
Interface OK Status Protocol Description
Port-channel 1 YES up up
Dell#
Example (detail
Command)
Dell#show server-interfaces detail
---------------- show server ports detail
---------------------
TenGigabitEthernet 0/1 is up, line protocol is up
Hardware is DellEth, address is 00:1e:c9:de:03:79
Current address is 00:1e:c9:de:03:79
Server Port AdminState is N/A
Pluggable media not present
Interface index is 33886978
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :001ec9de0379
MTU 12000 bytes, IP MTU 11982 bytes
LineSpeed 10000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 2d16h24m
Queueing strategy: fifo
76
Control and Monitoring