Command Line Reference Guide

* - Mismatch
Dell#
Related
Commands
show config (from INTERFACE VLAN mode) — displays information on a specific
physical interface or virtual interface.
show memory
Display current memory usage on the M I/O Aggregator.
Syntax
show memory [stack-unit 0–5]
Parameters
stack-unit 0–5 (OPTIONAL) Enter the keywords stack-unit then the stack
unit ID of the stack member to display memory information
on the designated stack member.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The output for show memory command displays the memory usage of LP part
(sysdlp) of the system. The sysdlp is an aggregate task that handles all the tasks
running on the CPU.
Example
Dell#show memory
Statistics On Unit 0 Processor
===========================
Total(b) Used(b) Free(b) Lowest(b) Largest(b)
268435456 4010354 264425102 264375410 264425102
show processes cpu
Display CPU usage information based on processes running.
Syntax
show processes cpu [management-unit 1-99 [details] | stack-unit
0–5 | summary | ipc | memory [stack-unit 0–5]]
Parameters
management-
unit 1-99
[details]
(OPTIONAL) Display processes running in the control
processor. The 1-99 variable sets the number of tasks to
display in order of the highest CPU usage in the past five (5)
seconds. Add the keyword
details to display all running
processes (except sysdlp). Refer to Example (management-
unit).
Control and Monitoring
67