Command Line Reference Guide

Command

History

Version 8.3.17.0 Supported on the M I/O Aggregator.

Usage

Information

The hostname is used in the prompt.

ip telnet server enable

Enable the Telnet server on the switch.

Syntax

ip telnet server enable

To disable the Telnet server, use the no ip telnet server enable command.

Defaults Enabled

Command

Modes

CONFIGURATION

Command

History

Version 8.3.17.0 Supported on the M I/O Aggregator.

ip telnet source-interface

Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.

Syntax

ip telnet source-interface interface

Parameters

interface Enter the following keyword and slot/port or number

information:

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

• For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Defaults The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

Command

Modes

CONFIGURATION

Command

History

Version 8.3.17.0 Supported on the M I/O Aggregator.

Control and Monitoring