Command Line Reference Guide

Usage
Information
This command displays internal software driver information, which may be useful
during troubleshooting switch initialization errors, such as a downed Port-Pipe.
terminal monitor
Configure the Dell Networking OS to display messages on the monitor/terminal.
Syntax
terminal monitor
To return to default settings, use the terminal no monitor command.
defaults Disabled.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
logging monitor— sets the logging parameters on the monitor/terminal.
Storm Control
The Dell Networking operating software storm control feature allows you to limit or suppress traffic
during a traffic storm.
Important Points to Remember
• Interface commands can only be applied on physical interfaces (virtual local area networks [VLANs]
and link aggregation group [LAG] interfaces are not supported).
PMUX Mode of the I/O Aggregator
437