Command Line Reference Guide

ip igmp group-join-limit
To limit the number of IGMP groups that can be joined in a second, use this feature.
Syntax
ip igmp group-join-limit number
Parameters
number Enter the number of IGMP groups permitted to join in a
second. The range is from 1 to 10000.
Defaults none
Command
Modes
CONFIGURATION (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.6.1.0 Introduced on the E-Series.
ip igmp querier-timeout
Change the interval that must pass before a multicast router decides that there is no longer another
multicast router that should be the querier.
Syntax
ip igmp querier-timeout seconds
To return to the default value, use the no ip igmp querier-timeout
command.
Parameters
seconds Enter the number of seconds the router must wait to
become the new querier. The range is from 60 to 300. The
default is 125 seconds.
Defaults 125 seconds
Command
Modes
INTERFACE
PMUX Mode of the I/O Aggregator
397