Command Line Reference Guide

Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0) Added the support for interfaces.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To
place an interface in mode, ensure that the interface’s configuration does not
contain an IP address and enter the Port Channel Commands command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example
Dell(conf)#interface tengig 0/1
Dell(conf-if-tengig-0/0)#exit#
Related
Commands
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
show interfaces — displays the interface configuration.
interface vlan
Configure the default VLAN to enable Static or DCHP IP configuration
Syntax
interface vlandef-vlan-id
Parameters
def-vlan-id Enter 1 for the default VLAN.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
For more information about VLANs and the commands to configure them, refer to
Virtual LAN (VLAN) Commands.
PMUX Mode of the I/O Aggregator
383