Command Line Reference Guide

show interface dcbx detail
Displays the DCBX configuration on an interface.
Syntax
show interface port-type slot/port dcbx detail
Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To clear DCBX frame counters, use the clear dcbx counters interface
stack-unit/port command.
The following describes the show interface dcbx detail command shown in
the following example.
Field Description
Interface Interface type with chassis slot and port number.
Port-Role Configured the DCBX port role: auto-upstream, auto-
downstream, config-source, or manual.
DCBX Operational
Status
Operational status (enabled or disabled) used to elect a
configuration source and internally propagate a DCB
configuration. The DCBX operational status is the
combination of PFC and ETS operational status.
Configuration
Source
Specifies whether the port serves as the DCBX configuration
source on the switch: true (yes) or false (no).
Local DCBX
Compatibility
mode
DCBX version accepted in a DCB configuration as
compatible. In auto-upstream mode, a port can only receive
a DCBX version supported on the remote peer.
Local DCBX
Configured mode
DCBX version configured on the port: CEE, CIN, IEEE v2.5,
or Auto (port auto-configures to use the DCBX version
received from a peer).
Peer Operating
version
DCBX version that the peer uses to exchange DCB
parameters.
Local DCBX TLVs
Transmitted
Transmission status (enabled or disabled) of advertised DCB
TLVs (see TLV code at the top of the show command
output).
358
PMUX Mode of the I/O Aggregator