Command Line Reference Guide

To remove a DCB map from an interface, enter the no dcb-map map-name
command in Interface configuration mode.
Related
Commands
show qos dcb-map– displays the dcb-map profiles configured on the system.
dcb-policy input stack-unit stack-ports all
Apply the specified DCB input policy on all ports of the switch stack or a single stacked switch.
Syntax
dcb-policy input stack-unit {all | stack-unit-id} stack-ports
all dcb-input-policy-name
To remove all DCB input policies applied to the stacked ports and rest the PFC to
its default settings, use the no dcb-policy input stack-unit all command.
To remove only the DCB input policies applied to the specified switch, use the no
dcb-policy input stack-unit
command.
Parameters
stack-unit-id Enter the stack unit identification.
dcb-input-
policy-name
Enter the policy name for the DCB input policy.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The dcb-policy input stack-unit all command overwrites any previous
dcb-policy input stack-unit stack-unit-id configurations. Similarly, a
dcb-policy input stack-unit stack-unit-id command overwrites any
previous
dcb-policy input stack-unit all configuration.
dcb-policy output
Apply the output policy with the ETS configuration to an egress interface.
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
policy-name Enter the output policy name.
Defaults none
338
PMUX Mode of the I/O Aggregator