Command Line Reference Guide

NOTE: You can identify stack port numbers by physical
inspection of the rear modules. The numbering is the
same as for the 10G ports. You can also inspect the
output of the show system stack-ports command.
unit 0–0
{counters |
details | port-
stats [detail] |
register}
Enter the keyword unit then 0 for port-pipe 0, and then
enter one of the following keywords to troubleshoot errors
on the selected port-pipe and to give status on why a port is
not coming up to register level:
counters, details, port-
stats [detail], or register.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example (show
hardware
stack-unit phy-
firmware-
version
Command)
Dell#show hardware stack-unit 1 phy-firmware-version
PortNumber Status Programmed Version SW
Version
===============================================================
========
41 Present 01.05
01.05
42 Present 01.05
01.05
43 Present 01.05
01.05
44 Present 01.05
01.05
45 Not Present N/A
N/A
46 Not Present N/A
N/A
47 Not Present N/A
N/A
48 Not Present N/A
N/A
49 Present 01.06
01.06
50 Present 01.06
01.06
51 Present 01.06
01.06
52 Present 01.06
01.06
53 Present 01.06
01.06
54 Present 01.06
01.06
55 Present 01.06
01.06
56 Present 01.06
01.06
Dell#
294
Debugging and Diagnostics