Command Line Reference Guide

Related
Commands
reload— reboots the system.
show system— displays the current status of all stack members or a specific
member.
stack-unit iom-mode
Toggle the M I/O Aggregator operating mode between programmable multiplex, stand-alone, stack, and
VLT modes.
Syntax
stack-unit <unit-number> iom-mode [programmable-mux | stack |
standalone | vlt]
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is
from 0 to 5.
programmable
-mux
Enable programmable multiplex mode.
stack Enable stack mode.
standalone Enable stand-alone mode.
vlt Enable virtual link trunking mode.
Defaults standalone
Command
Modes
• CONFIGURATION
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell(conf)#stack-unit 0 iom-mode stack
% You are about to stack your IOA module, please reload the IOA
and then plug in the stacking cable for the changes to take
effect.
Dell(conf)#
Dell#
Related
Commands
reload— Reboots the operating system.
show system— displays the current status of all stack members or a specific
member.
266
Stacking Commands