Command Line Reference Guide

not present
Dell#01:02:12: %STKUNIT0-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack
unit 1 down - card
removed
Related
Commands
reload— reboots the system.
power-cycle stack-unit— resets the designated stack member.
show system stack-ports
Display information about the stacking ports on all switches in the M I/O Aggregator switch stack..
Syntax
show system stack-ports [status | topology]
Parameters
status (OPTIONAL) Enter the keyword status to display the
command output without the Connection field.
topology (OPTIONAL) Enter the keyword topology to limit the table
to just the Interface and Connection fields.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The following describes the show interfaces command shown in the following
example.
Field Description
Topology Lists the topology of stack ports connected: Ring, Daisy
chain, or Standalone.
Interface The unit/port ID of the connected stack port on this unit.
Link Speed Link Speed of the stack port (10 or 40) in Gb/s.
Admin Status The only currently listed status is Up.
Connection The stack port ID to which this unit’s stack port is
connected.
Example
Dell# show system stack-ports
Topology: Ring
Interface Connection Link Speed Admin Link Trunk
(Gb/s) Status Status Group
0/33 40 up down
262
Stacking Commands