Command Line Reference Guide

Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
The following describes the show ip fib stack-unit command shown in the
following example.
Field Description
Destination Displays the destination route of the index.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit.
1 indicates that a packet hitting this entry is forwarded to the
control processor, depending on Egress port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of
a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the
entry to determine the interface. For example, in the entry
17cl CP, the CP is the pertinent portion.
• CP = control processor
• Fo= 40 Gigabit Ethernet interface
• Te = 10 Gigabit Ethernet interface
Example
Dell#show ip multicast-cam stack-unit 0 port-set 0
10.10.10.10/32
longer-prefixes
Destination EC CG V C VId Mac-Addr Port
----------------- -- -- - - ----- -----------------
-------------
10.10.10.10 0 0 1 1 0 00:00:00:00:00:00
3f01 CP
Dell#
show ip route
View information, including how they were learned, about the IP routes on the switch.
Syntax
show ip route [hostname | ip-address [mask] [longer-prefixes] |
list prefix-list [process-id] | connected | static | summary]
194
IPv4 Routing